Face Installation - Lennox Hearth Products RAVELLE 42 Installation And Operation Instructions Manual

Face Installation

A number of different faces are available for the Ravelle™ 42 gas fire-
place, however, all the faces are installed in a similar manner . A total of
four screws (two upper and two lower) attach the face to the fireplace .
To install a face:
1 . Locate the two screws found in the hardware bag shipped with the face .
Position the face (with the lower door open) in front of the fireplace .
Install the two screws, A in the diagram below, through the holes in
the lower door hinge bracket and screw them into the captive nut on
tab B located on the fireplace . Do not fully tighten these screws yet .
Figure 16
16
B
B
Expanded View
Expanded View
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
2 . Bracket C in the diagram below is installed on the face during the face
assembly (see instructions included with face) . The captive screws D
on this bracket should be screwed into captive nuts E on the fireplace .
A phillips head screwdriver inserted through the vent holes in the face
can be used to complete this task . Align the face for plumb and level
and then tighten all four screws .
CAUTION: Any masonry that has been cleaned with an acid
wash must be properly neutralized before installing the fire-
place face. The acid wash will tarnish the face. Consult your
masonry installer.
A
A
D
C
D
C
Expanded View
E
E
Expanded View