The blower box may be located in the wall, floor, or ceiling .
Ceiling and Wall Mounting:
1 . Fasten the two angled brackets to the side of the face
box with the screws provided (see A below) .
2 . Fasten the bracket in these
2. Fasten the bracket in
holes for 2 x 4 walls .
these holes for 2 x 4 walls.
Fasten the bracket in
Fasten the bracket in
these holes for 2 x 6 or
these holes for 2 x 6 or
greater walls or ceiling.
greater walls or ceiling.
Figure 38
Floor Mounting:
1 . Fasten the two floor mount adaptors (B below) to the side of the blower box with the screws provided . The floor mount adaptors have two sets
of holes . The upper holes (C below) should be used if the flooring material is thin and the lower holes (D below) should be used if the flooring
material is thick .
2 . Cut the hole (E below) for the blower box . Since the blower box body is wider than the portion that comes up through the floor an additional piece
of flooring (F below) should also be cut out for the blower box to slide through . (Save this piece F and nail it back in place after the blower box is
installed) .
3 . Slide the blower box through the cut holes and nail or screw it to the floor .