Surround Panels Installation; Face Installation - Lennox Hearth Products Elite Series Installation And Operation Manual

Surround Panels Installation
The Designer™ insert surround panels are made of heavy gage steel
for durability and, if desired, for the ease of making an inside fit in the
fireplace. See "Packaging List" for sizes available.
1. Remove the speed nuts from the parts bag and install (with the flat
surface forward) on the six holes in the surround brackets, three on
each side of the insert (See A in Figure 14). A flat bladed screwdriver
may help in installing the nuts.
2. Install all surround panels and trim with the insert positioned in the
fireplace but a few inches in front of its final location.
3. If the insert face is to be installed on the insert, the sight obstructor that
comes with the face must be installed prior to installing the surround
panels. With the curved edge down and the bent top edge positioned
toward the insert, slide the tabs at the ends of the obstructor in the
slots on the surround brackets (see C in Figure 14).
4. Install the side surround panels by lining up the holes in the tabs on the
side surround panels in front of the holes on the surround brackets.
Next insert two slotted 1/4" truss screws for each side surround panel
and secure loosely.
5. Fasten top surround panel with the remaining two truss screws.
Tighten all six truss screws after adjusting the surround panels to
eliminate space between side and top surround panels.
6. Assemble the surround trim by inserting the elbowed retainer in the
rectangular slot in the ends of the longest piece of trim and secure by
tightening the screw in the retainer. Slide the mitred ends of the two
side trim pieces onto the elbowed retainer and secure by tightening
the retainer screw.
7. The fastened trim pieces should now be horseshoe shaped. Slide the
trim down over the surround panels so the edge of the surround panel
fits just behind the rounded edge of the trim.
8. Install three spring clips (found in parts bag in firebox) in each piece
of trim by inserting them between the rear of the surround and the
channel of the trim. The spring clips will push the trim tight to the
surround.
C
Figure 14
Face Installation and Cleaning
A number of different face finishes and shapes are available for your
Designer™ Flush Gas Insert. The insert Face comes with a sight obstruc-
tor that must be installed prior to installing the surround panels (see
step 3 on Page 11) and face. The faces come with hooked brackets. To
install the face, hang the hooked bracket on the surround brackets (C
in Figure 14).
NOTE: GOLD PLATED SURFACE MUST BE CLEANED WITH GLASS
CLEANER AND SOFT RAG BEFORE FIRING THE FIRST TIME OR FINGER
PRINTS AND STAINS WILL REMAIN PERMANENTLY. NEVER USE BRASS
POLISH TO CLEAN GOLD, THIS WILL REMOVE GOLD PLATING!
Orifice Size / Altitude Adjustment
See instructions on Page 4
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
A
B
11