Wiring The Front Connector, Crimping; Wiring A Front Connector With Crimp Terminals - Siemens SIMATIC S7-400 Installation Manual

Wiring the S7-400
4.14

Wiring the Front Connector, Crimping

Procedure
To wire the prepared front connector:
1. Strip the conductors at a length of approx. 5 mm.
2. Crimp the contacts onto the conductors. A crimptool is aailable on order as an
accessory for your signal modules.
3. Insert the crimp contacts into the recesses of the front connector, starting at the
bottom.
The order number for crimp contacts is found in Appendix C of the Reference
Manual .
Figure 4-13
4-24

Wiring a Front Connector with Crimp Terminals

Automation System S7-400 Hardware and Installation
A5E00850741-01