Seiko I Infotech LP-1020 User Manual page 236

(1) Ethernet interface
Error code
Duplication of XPT port
0101
number
0212 Lack of internal memory
Protocol data sent from the
0220 to 022F
host is defective
Host disconnects the
communication forcibly
0250 to 025F
while a connection is
established
Communication to the host
0260 to 026F failed while communication
time out data is transferred
Communication connection
1000 to 4FFF
system error
Communication system
5000 to 7FFF
internal error
14-20
■Communication warnings
Description : A communication error message appears if any
communication error occurs between the computer and the
device. For a practical description, see the following table.
Measure : If the device does not recover from this error by turning
the power off and on, follow the guidelines described in
the Measure column of the table. If the error is not
removed, please notify your dealer or our service center
of the displayed error message and error condition.
◆ A communication warning appears on the LCD, but it
disappears when the next operation is performed.
Consequently, you may not recognize that the error
occurred. In such a case, retransmit the data to check if
the communication warning is displayed on the LCD.
W I N T E R F A C E - L N
Description
Note
x x x x
Measure
Specify the parameter at the device side correctly.
If the device does not recover from this error by
turning the power off and on, take the following
measures:
- Check if the communication condition and
protocol match the specifications of the computer.
- Check if the connection cable is defective or
is connected securely.
- If the error is not removed, please notify your
dealer or our service center of the displayed error
message and error condition.
xxxx: Error code