Table of Contents
Advertisement
Troubleshooting
■Items to be checked
Symptom
No power
Failure to start or
operate correctly
Failure to plot
Failure to plot
transmitted data
immediately
Frequent paper
jam
14-2
Before calling your dealer or our service center, check the following
items and take corrective measures.
Items to be checked
Power cable connection
Power supply to the outlet Supply the power to the outlet.
ERROR llights and LC
message display
Interface cable connection Connect the interface cable correctly.
ERROR lights and LC
message display (See
"Note" below)
DATA lghts
(on or flashing?)
Paper type
Paper roll
Check whether there is
any foreign material in
the paper path
◆ In case of a communication warning or data error, the
ERROR lamp does not light. Also, an error message,
even if displayed, will disappear when the next operation
is performed.
If a problem occurs between the computer and the device
immediately after the line connection, check the LCD for
presence of a communication warning (⇒ page 14-20) at
the time of transmission of data to the device.
For a data error, an error message can be printed on the
drawing (⇒ page 14-22).
Corrective measure
Plug the power cable into the outlet correctly.
Take appropriate measures according to the
error message. ⇒Page 14-3
Take appropriate measures according to the
error message. ⇒Page 14-3
Review the time-out setting.
Check whether the paper type setting matches
the type of the loaded paper. ⇒Page 7-2
Use our recommended paper. ⇒Page 1-7
Load the paper correctly. ⇒Page 2-16
Remove any foreign material.
( "Paper Jam" ⇒Page 14-3)
Note
Advertisement
Table of Contents
Troubleshooting
