Seiko I Infotech LP-1020 User Manual page 140

■SCALE X (%)
SCALE Y (%)
<Parameter (numerical value input method)>
0.01 to 1000.00
■PEN WIDTH SCALE (HP-GL, DSCAN only)
<Parameter (choice input method)>
ON
OFF
■FIX SCALE A
FIX SCALE 9"
FIX SCALE 8.5"
5-22
When setting "SCALE MODE = MANUAL SCALE," values of the scale
applied to X and Y directions of the drawing are set up.
This setting is performed on the third hierarchy.
Default value = 100
This setting is enabled when setting "SCALE MODE = MANUAL
SCALE." When it is set to 100%, the plot is produced in 1-to-1
magnification.
Sets the scaling down method, when the drawing is scaled down (in the
same X and Y proportion). This setting is performed on the third
hierarchy.
Line width or interval between points are also scaled down.
Maximum line width is 16 mm (0.63 inches).
Line width or interval between points are not scaled down.
Allows for setting the method of automatic scale from one fixed form to
another when setting "SCALE MODE = MANUAL SCALE." This
setting is disabled when plotting in the actual length or expanded fixed
form. This setting is performed on the third hierarchy.
: Default value