SATO LM400e Series Quick Manual page 26

4
Place an empty ribbon core on the
ribbon take-up spindle.
5
From the ribbon supply spindle,
thread the carbon ribbon under
the thermal head and to the
ribbon take-up spindle.
Tape the free end of carbon
ribbon to the ribbon core, and
wind a few times in the direction
of an arrow.
Be sure to confirm that the carbon
ribbon is set as shown in the picture
on the right.
Caution
*Thermal head and the surrounding
areas will become hot during the
printing process.
When changing the labels after
printing, be careful not to get burnt.
*Contacting the edge of thermal head
with bare hands may result in injury.
When changing the labels, be
careful not to get injured.
Ribbon
take-up
spindle
Tape
Ribbon core
16