Replacing The Fan Shaft Assembly - Kodak EKTAGRAPHIC III AM Service Manual

Replacing the FAN SHAFT ASSEMBLY

A100_0013HCA
A100_0013HA
Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER HOUSING ASSEMBLY.
[3] Cut the 3 WIRE TIES:
• 1 on BLOWER COVER wires
• 2 on SMALL CIRCUIT BOARD between the MOTOR and MECHANISM ASSEMBLY
[4] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.
[5] Pull the SMALL CIRCUIT BOARD up.
[6] Remove the Torx SCREW from the BLOWER COVER ASSEMBLY.
[7] Lift the GRILLE ASSEMBLY in front of the BLOWER COVER ASSEMBLY up.
[8] Loosen the Torx SCREW on the right track of the LOWER LIGHT BAFFLE ASSEMBLY appoximately half way.
[9] Lift the LOWER LIGHT BAFFLE ASSEMBLY off the TAB on the BLOWER COVER ASSEMBLY.
[10] Remove the 2 long Torx SCREWS from the BLOWER COVER ASSEMBLY.
SM4530-1 – 30APR96
Replacements and Installations
WIRE TIE (not shown)
BR and KK models
BLOWER COVER WIRE TIE
GRILLE ASSEMBLY
5