Table of Contents
Advertisement
Resetting Menu Items
The values for particular parameters can be reset
individually. This allows you to restore the default
setting if you are unsatisfied with the adjusted values.
Some parameters are shared between features and,
if reset in one area, will be reset in all areas that share
that parameter.
To reset individual menu items:
1.
Select the menu for the value you wish to reset.
2.
Double press the knob associated with the value.
Restoring to Factory Defaults
You can restore your switcher to the factory default
settings. You may wish to do this when
troubleshooting problems with your switcher. Refer to
Table 9 for a list of factory default settings.
Restoring to factory defaults resets the entire
switcher. Save any configuration information to a
memory register if you wish to re-load it after
performing the factory default.
To restore factory defaults:
1
2
1.
Press MENU.
2.
Press the RESET Wipe Pattern button.
3.
Press NEXT.
4.
Press the Factry Reset knob.
5.
Press the Confrm knob to perform the reset.
Press the Cancel knob to cancel the reset.
USB Storage
You can use a USB drive to:
• Save and load sets of memory registers,
personality, and installation settings to and from a
USB drive
• Perform software upgrades
These files and settings can be copied from the USB
drive and backed-up on your computer.
Note:
• Wait 5 seconds after inserting a USB drive into the
USB port before using it.
38
4
3
For More Information on...
• performing software upgrades, refer to the section
"Software Upgrades" on page 39.
Saving Memory Registers, Personality, and
Installation Settings
You can save up to 10 sets of memory registers,
personality settings, and installation settings on a
USB drive.
To save to a USB drive:
2
3
1.
Insert a USB drive into the USB port.
2.
Press MENU.
3.
Press the SAVE Wipe Pattern button.
4.
Use the left knob to select the set you wish to
save to.
5.
Save memory registers, personality settings,
installation settings, or all settings as follows:
• Press the All knob to save memory registers,
personality settings, and installation settings
to the selected set.
• Press the Mems knob to save memory
registers to the selected set.
• Press NEXT and then the Pers knob to save
personality settings to the selected set.
• Press the Inst knob to save installation
settings to the selected set.
6.
Press the Confrm knob to perform the save.
Press the Cancel knob to cancel the save.
Note:
• Turn the middle knob when browsing sets to
display the full text of long set names
• Saving items overwrites the same items in the
selected set (e.g. saving memory registers
overwrites previously saved memory registers in
the selected set but does not affect personality or
installation settings previously saved to the same
set).
• The * symbol next to an item indicates that there is
a previously saved version of that item in the
selected set.
4,5
Advertisement
Table of Contents
