Table of Contents
Advertisement
0.444"
1
0.504"
Figure 5 Insert Sizing
To install switcher button inserts:
1.
Remove the Cap Assembly (1) from the Switch
Assembly (2) by grasping it firmly and pulling
away from the control panel surface.
2.
Remove the Lens (1) from the Diffuser (2) using
a common end micro screwdriver.
3.
Place the Insert Film (2) into the Lens (1) so the
readable side is facing up. The notches on the
sides of the Lens must be at the sides of the text
on the Insert Film.
4.
Aligning the notches on the sides of the Lens (1)
and Diffuser (3), press the Lens and Diffuser
together until they click.
5.
Aligning the notches on the sides of the Cap
Assembly (1) to the tabs on the side of the
Switch Assembly (2), press Cap Assembly down
onto the Switch Assembly with a rolling motion
until they click together.
4
0.468"
2
0.528"
1
2
1
2
1
2
3
Shift
Shifting allows access to the secondary sources for
each source button.
To shift a bus and access the secondary sources:
2
1.
Press and hold SHIFT.
2.
Press the required source button to access the
secondary source.
Fader
The Fader is used to manually perform a wipe or
dissolve transition. Move the Fader handle from one
limit to the other to perform a transition.
Transitions
The progress of the transition is shown on the
Progress Bar to the left of the Fader handle. As the
Fader handle moves from one limit to the other, the
Progress Bar indicates the progress of the transition.
Positioner
The KM-H3000 has a joystick positioner for
positioning wipes, patterns, washes, and DVE effects.
The KM-H2500 does not have a positioner.
Selecting Colors
Functions such as mattes, and Panel Glow have
options for adjusting the appearance of a selected
color. Individual adjustments for colors are:
• Luminance
• Hue
• Saturation
1
2
1
Advertisement
Table of Contents
