Table of Contents
Advertisement
4.
Press NEXT until Load is displayed.
5.
Use the Load knob to select the color scheme
you want to load. You can select from a list of
presets or one of the custom color schemes you
have previously saved.
6.
Press the Load knob to load the color scheme.
7.
Press the Confrm knob to commit the load.
Press the Cancel knob to cancel the load.
Power-Save Mode
The switcher goes into a Power-Save mode after a
user-defined amount of time (20 minutes by default)
without user interaction. Touching any control will
wake the switcher. Any functionality associated with
the touched control is ignored until the unit is active
and all lights and display are turned on.
During Power-Save mode, video related hardware is
not affected and video signals are still passed through
the switcher.
To configure the power-save timeout:
1
2
1.
Press MENU.
2.
Press the PERS Wipe Pattern button.
3.
Press the right knob to set the switcher
power-save behavior. You can choose from the
following:
• PwrSve — All buttons and the menu display
turn off. The switcher conserves as much
power as possible without affecting on-air
video.
• Sleep — The menu display turns off. Buttons
light and slowly fade in a raindrop pattern.
4.
Use the right knob to set the power-save timeout
(in minutes). You can select a value from 0 (off)
to 999 minutes.
Transition Rate Units
You can select the units used to specify durations for
various video transitions. Choose the units that you
are most comfortable working with.
3
To select the units for switcher transitions:
1
2
1.
Press MENU.
2.
Press the PERS Wipe Pattern button.
3.
Use the Rate knob to select the units used to
specify switcher transition rates. You can choose
from the following:
• Frames — Switcher transitions are specified
in frames.
• Secnds — Switcher transitions are specified
in seconds.
Double-Press Rate
You can set the double-press rate of the switcher to
suit your preference. Setting a fast rate requires you
to double-press the knobs in quick succession in
order to be recognized as a double-press. Setting a
slow rate allows more time between presses but may
register two single presses as a double-press.
To set the switcher double press rate:
1
2
1.
Press MENU.
2.
Press the PERS Wipe Pattern button.
3.
Press the DblPrs Speed knob.
4.
Double-press the middle knob at a rate you feel
is comfortable. This defines the double-press
rate.
5.
Press MENU to save the setting.
Resource Sharing
The switcher can use one Chroma Key and two
channels of DVE simultaneously. You can specify
how the Chroma Key is shared between keys and the
DVE resources are shared between keys and the
transition area on your switcher.
3
3
4
17
Advertisement
Table of Contents
