Table of Contents
Advertisement
To assign sources to the MultiView display:
2
1
1.
Press MENU.
2.
Press the SYSTEM Wipe Pattern button.
3.
Press the MultiView knob to display the
MultiView menu.
4.
Press NEXT.
5.
Use the Box knob to select a box on the
MultiView display.
6.
Use the In/Out knob to select a source to display
in the box You can choose from the following:
• PGM — Program bus output
• PV — Preset bus output
• 1-12 (1-6 for KM-H2500) — Source inputs
• M1-4 — Media-Store channels
Note:
• Media-Store channels 3 and 4 are only available
when the Media-Store mode is set to Dual.
• Inputs assigned to boxes 3-10 are displayed with a
red border when they are on-air. A green border is
displayed when the input is selected on the Preset
bus.
• Boxes 1 and 2 do not have colored borders.
For More Information on...
• setting the Media-Store mode, refer to the section
"Media-Store Mode" on page 19.
KM-H CleanSwitch
KM-H CleanSwitch allows you to perform high-quality
transitions between video signals with embedded
audio streams.
The setup consists of your switcher, a Ross Video
openGear DFR-8300 series frame, and an
MDK-111A-Lite.
Refer to your Ross Video KM-H CleanSwitch
documentation for details on cabling and transition
behavior.
14
5
6
3
4
To configure your switcher for External Audio
mode:
2
1
3
1.
Press MENU.
2.
Press the SYSTEM Wipe Pattern button.
3.
Press NEXT until Ext Audio is displayed.
4.
Press the Ext Audio knob to display the External
Audio menu.
7
5.
Use the ExtAud knob to enable or disable
external audio switching.
6.
Use the Type knob to select the type of audio
transition that is performed. You can choose from
the following:
• X-Fade — Audio from the source going on-air
is simultaneously faded up to full volume while
the audio from the source going off-air is
faded to no volume.
• V-Fade — Audio from the source going off-air
is faded to no volume and then the audio from
the source going on-air is faded to full volume.
7.
Press NEXT until IPAddr is displayed.
8.
Use the Field knob to select the various fields in
the IP address.
9.
Use the Value knob to modify the field values
and enter the IP address of your Ross Video
MDK-111A-Lite card.
10. Press the IPAddr knob to save the IP address.
11. Press the Confrm knob to commit the change
and exit the menu. Press the Cancel knob to
return to the External Audio menu for further
editing.
Note:
• Ensure that Frame Sync is turned off for any input
or bus you are using with external audio mode.
4
5 6,8
9
Advertisement
Table of Contents
