Roberts CR9951 Manual
  1. Manuals
  2. Brands
  3. Roberts Manuals
  4. Clock Radio
  5. CR9951
  6. Manual
Roberts CR9951 Manual

Roberts CR9951 Manual

3 band single alarm clock radio
Hide thumbs
Table of Contents

Advertisement

Quick Links

CR9951
3 Band Single Alarm
Clock Radio
Please read this manual before use

Advertisement

Table of Contents
loading

Related Manuals for Roberts CR9951

Summary of Contents for Roberts CR9951

  • Page 1 CR9951 3 Band Single Alarm Clock Radio Please read this manual before use...
  • Page 2 Controls (Top) (Left side) (Right side) 5. Waveband selector 9. AL. Set/off button 1. Dimmer switch 6. Tuning control 10. Time button 2. Function switch 11. Minute button 7. Snooze button 3. Headphone socket 8. Sleep button 12. Hour button 4.
  • Page 3 Controls (Front) 16. Rating plate (underside) 13. PM indicator 17. Alarm indicator 14. LED dial pointer 15. Battery compartment (underside) If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri)

  • Page 4: Switching On And Setting The Time

    Switching on and setting the time Before using your clock radio you must first set the correct time. 1. Check that the supply voltage agrees with the voltage indicated on the rating plate on the bottom of the product. Place the unit on a flat surface.

  • Page 5: Listening To The Radio

    Listening to the Radio 1. Turn on the radio by sliding the Function switch to the 'On ' position. The LED dial pointer will light up indicating that the radio is switched on. 2. Select the required waveband using the Waveband selector switch.
  • Page 6 Alarm The alarm can be set to wake you by either the buzzer or the radio. Setting alarm time 1. Press and hold down the AL.Set/off button 2. Whilst holding down the Alarm Set button/Off button press the Hour, or Minute buttons to set the time. Release the buttons when the correct alarm time is reached.

  • Page 7: Setting The Alarms To Wake To Radio

    Setting the alarm to wake to buzzer 1. Set the alarm time as previously described. Set the Function switch to the Buzz position. The Alarm indicator will light. The alarm will sound every day at the preset time for 1 hour 59 minutes.

  • Page 8: Snooze Control

    Snooze control The radio or buzzer alarm can be silenced for 9 minutes by pressing the Snooze button. This sequence can be repeated whilst the alarm is sounding. Sleep timer The radio can be set to turn off after a preset time has elapsed. Press and hold down the Sleep button until the desired time is reached (maximum 59 minutes in 1 minute steps).
  • Page 9 Headphones (on rear) A Headphone Socket (3.5mm) is provided for use with either headphones or an earpiece . Inserting a plug automatically mutes the internal loudspeaker. If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri)

  • Page 10: Mains Supply

    Back-up Battery (not necessary for the unit to function) Slide the battery cover catch in the direction of the arrow. Remove the The CR9951 will operate from a supply of AC 230volts, 50Hz battery cover. Fit a 9 volt IEC size 6LR61(6F22,PP3) or equivalent only as advised on the rating plate on the cabinet bottom.

  • Page 11: Specifications

    Specifications Circuit Features Power Requirements Loudspeaker 75mm diameter 8 ohms Mains AC 230 volts, 50Hz only Output Power 0.3W RMS Back-up Battery IEC size 6LR61 (6F22,PP3) Aerial System Wire Aerial Frequency Coverage 87.5 - 108MHz Built-in Ferrite aerial 525 - 1610kHz 147 - 284kHz Built-in Ferrite aerial The Company reserves the right to amend the specification without notice.
  • Page 12 In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please contact Roberts Radio Technical Services at the address shown below. These statements do not affect the statutory rights of a consumer.

Table of Contents