Roberts CR9901 Manual

Roberts CR9901 Manual

3 band single alarm clock radio

Advertisement

Quick Links

CR9901
3 Band Single Alarm
Clock Radio
C R 9 9 0 1
3 B a n d C lo c k R a d io
Please read this manual before use

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CR9901 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Roberts CR9901

  • Page 1 CR9901 3 Band Single Alarm Clock Radio C R 9 9 0 1 3 B a n d C lo c k R a d io Please read this manual before use...
  • Page 2 Controls (Top) C R 9 9 0 1 3 B a n d C lo c k R a d io (Left side) (Right side) 1. Dimmer switch 5. Waveband selector 9. Alarm/Off button 2. Function switch 6. Tuning control 10.
  • Page 3 Controls (Front) 1 5 0 1 7 0 2 1 0 2 4 0 2 6 0 k H z 5 4 0 6 0 0 8 0 0 1 0 0 0 1 3 0 0 1 6 0 0 k H z 1 0 0 1 0 4...
  • Page 4: Switching On And Setting The Time

    Switching on and setting the time Before using your clock radio you must first set the correct time. 1. Place the unit on a flat surface. Plug the power cord into the wall socket 1 5 0 1 7 0 2 1 0 2 4 0 2 6 0...
  • Page 5: Listening To The Radio

    Listening to the Radio O ff B u z z A u to O n 1. Turn on the radio by sliding the Function switch to the 'On' position. 1 5 0 1 7 0 2 1 0 2 4 0 2 6 0 k H z The LED dial pointer will light up indicating that the radio is...
  • Page 6: Setting Alarm Time

    Alarm The alarm can be set to wake you by either the buzzer or the radio. Setting alarm time 1. Press and hold down the Alarm/Off button. 2. Whilst holding down the Alarm/Off button press the Hour, or Minute buttons to set the time. Release the buttons when the correct alarm time is reached.
  • Page 7: Setting The Alarms To Wake To Radio

    Setting the alarm to wake to buzzer O ff B u z z A u to O n 1. Set the alarm time as previously described. Set the Function switch to the 'Buzz' position. The Alarm indicator will light. The alarm will sound every day at the preset time for 59 minutes. To turn off the alarm until the next day press the Alarm/Off button.
  • Page 8: Snooze Control

    Snooze control The radio or buzzer alarm can be silenced for 7 minutes by pressing the Snooze button. This sequence can be repeated whilst the alarm is sounding. Sleep timer The radio can be set to turn off after a preset time has elapsed. Press and hold down the Sleep button until the desired time is reached (maximum 59 minutes in 1 minute steps).
  • Page 9 IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN. Mains supply Back-up Battery (not necessary for the unit to function) The CR9901 will operate from a supply of AC 230volts, 50Hz only. For your convenience this product is supplied with a plug which is fitted Slide the battery cover catch in the direction of the arrow.
  • Page 10: Specifications

    Wire Aerial Frequency Coverage 87.5 - 108MHz Built-in Ferrite aerial 525 - 1610kHz 147- 284kHz Built-in Ferrite aerial ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice.
  • Page 11 Notes: If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri)
  • Page 12 In the event that it is not possible to return the instrument to the Roberts dealer from whom it was purchased, please contact Roberts Radio Technical Services department at the address shown below before taking further action.

Table of Contents