Adjusting The Stitch Length; Fitting A Needle - JUKI AE-200A Instruction Manual

10. Adjusting the stitch length

A
1

11. Fitting a needle

CAUTION
:
To avoid possible accident due to abrupt start of the sewing machine, turn off the power to
the machine beforehand.
2
1
Bottom feed length
)
2)
)
2
Top feed length
Refer to
amount readout potentiometer" on page 64
how to adjust the top feed length.
* Turn off the power to the motor.
Use DBx (DPx for the DP type sewing machine)
needle.
)
D B
2)
A
C
)
4)
5)
− 0 −
Turn stitch dial 1 in the direction of the arrow
until a desired numeral is aligned with marker
dot A on the machine arm.
The numerals are given in millimeters (mm).
To change the feed length from a larger value to
a smaller value, turn stitch dial 1 while pressing
feed lever 2 in the direction of the arrow.
"^ -18. Correcting the bottom feed
Turn the handwheel to move the needle bar up
to its highest position.
Loosen needle clamping screw 2 . Hold needle
1 so that its scarf A faces exactly to the right B .
Insert the needle fully into the hole in the needle
bar in the direction of the arrow until it goes no
further.
Securely tighten needle clamping screw 2 .
Check to be sure that slot C in the needle faces
just left D direction.
for