Table of Contents
Advertisement
Installation Instructions
Pitch Adjustment
NOTE:
Pitch can be adjusted using the projector mount or the
pitch of the entire arm can be adjusted. See "Pitch
Adjustment - Entire Arm Section for details.
1.
Loosen Pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 19)
2.
Turn Pitch micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 19)
3.
Tighten Pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 19)
2
2
Figure 19
Roll Adjustment
1.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 20)
2.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 20)
3.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 20)
1
3
2
Figure 20
Visit the InFocus support site at www.infocus.com/support
Pitch Adjustment - Entire arm
1.
2.
1
3
(underside)
3.
4.
5.
2
6.
7.
Remove two #8-32 x 3/4" Phillips pan machine screws (F)
to free outer cover from mounting bracket. (See Figure 21)
(F) x 2
1
Figure 21
Slide outer cover of mount (A) away from mounting bracket
to expose pitch adjustment screw. (See Figure 22)
mounting bracket
pitch adjustment screw
2
Figure 22
Loosen two 5/16-18 x 1/2" screws (C) on each side of
mounting bracket. (See Figure 22)
Loosen two bolts on either side of pitch adjustment screw.
(See Figure 22)
Adjust pitch adjustment screw until mount is at desired pitch
level. Turn clockwise to raise mounting level or turn
counterclockwise to lower mounting level. (See Figure 22)
Tighten two bolts on either side of pitch adjustment screw.
(See Figure 22)
Tighten two 5/16-18 x 1/2" screws (C) on each side of
mounting bracket. (See Figure 22)
SP-WALLKIT-01
11
Advertisement
Table of Contents
