InFocus LP340 Installation Instructions

Installation Instructions
SP-CEIL-LM3X
Ceiling Mount Kit for
LP340/350 Projectors
This kit makes it easy to hang your projector
from the ceiling for fixed installation use in
meeting, auditorium and training room
settings. A unique quick-release feature
allows you to take the projector down in
seconds to replace the lamp or move the
projector to another location.
! !
- IMPORTANT -
Projector installation must be performed by
qualified personnel in compliance with local
building code requirements. These
requirements take precedence over any
instructions provided here.
Ensure that the ceiling is capable of
supporting a weight five times that of the
projector. If it cannot, reinforce the ceiling to
provide a safe installation.
Package Contents
§
Installation instructions
§
1 – 4mm x 10mm knurled knob
screw
§
1 – projector mounting bracket
§
2 – 4mm x 16mm Phillips screws
§
2 – 4mm quick release sleeves
§
1 – ceiling mount base box
§
2 – 6mm x 12 mm hinge pin bolts
§
2 – 6mm x 12mm angle locking
bolts
§
2 – 6mm flat washers
§
2 – conical spacers
Attach the Mounting Bracket
1
to the projector
1. With the projector on its top, loosely
fasten the two quick release sleeves (E)
to the projector. Use the two 4mm x
16mm Phillips screws (D).
2. Position the mounting bracket (B) against
the projector with the keyholes over the
two screw heads (D). Move the bracket
toward the rear of the projector to fully
engage the screws in the narrow keyhole
slots.
3. Thread the 4mm x 10mm knurled knob
screw (A) through the mounting bracket
into the hole near the rear of the
projector.
4. Tighten all three screws securely.
Install the Ceiling Mount Base Box
2
on the Ceiling
- NOTE -
Refer to the LiteMount False Ceiling Plate and
LiteMount Pipe Tubing Extension installation
instructions if you have purchased these items
to reinforce a suspended ceiling or to position
the projector away from the ceiling. Install
these items before proceeding with the
instructions below.
! !
- IMPORTANT -
Use appropriate hardware to ensure that the
ceiling box is fastened securely to the ceiling.
No hardware is included for this purpose.
1. Examine the flanges on each side of
the ceiling mount base box to identify
its front and rear orientation on the
ceiling. The holes near the edge of
each flange will be closest to the rear
of the projector when the installation is
complete.
REAR SIDE