Table of Contents
Advertisement
Installation Instructions
17. Make sure latching flags are in "closed" position prior to
using mount!
IMPORTANT ! : Manufacturer recommends using cable
ties (C) or padlock (not included) to secure the latching
flags in closed position on both sides. (See Figure 37)
flags in "closed"
position
Figure 37
Adjustments
Height Adjustment
1.
Press "UP" or "DOWN" buttons to raise or lower height as
desired. (See Figure 38)
"DOWN"
"UP"
Figure 38
Save Height Levels
1.
Adjust height until desired preset level is reached using
"UP" and "DOWN" buttons. (See Figure 38)
2.
Press "SAVE" button. (See Figure 38)
3.
Press one of three preset buttons (., .. or ...) to save preset
position. (See Figure 38)
4.
Repeat Steps 1-3 as desired.
(C) x 2
"PRESETS"
"SAVE"
Leveling Adjustment
1.
Adjust leveling adjustment screws through access holes to
level mount as desired +/- 3/4". (See Figure 39)
+/- 3/4"
+/- 3/4"
Figure 39
Plumb Adjustment
2.
Adjust plumb adjustment screws as desired to adjust plumb
+ 3°. (See Figure 40)
Figure 40
INF-MOTWALL / XSD1U
+ 3°
19
Advertisement
Table of Contents
