Table of Contents
Advertisement
SP-WALLKIT-01
or
5
Figure 23
8.
Slide outer cover of mount (A) back against mounting
bracket.
9.
Reinstall two #8-32 x 3/4" Phillips pan machine screws (F)
through holes on sides of outer cover. (See Figure 24)
(F) x 2
9
Figure 24
12
4
6
(C) x 2
3
7
Visit the InFocus support site at www.infocus.com/support
Cable Management (Optional)
1.
Remove two #8-32 x 3/4" Phillips pan machine screws (F)
to free outer cover from mounting bracket. (See Figure 25)
(F) x 2
1
Figure 25
2.
Slide outer cover of mount (A) away from mounting bracket.
(See Figure 25)
NOTE:
In most cases, cable management covers will NOT
need to be removed in order to route cables from
projector to the wall mount. But for some thick cables,
removing the covers may be necessary.
3.
Remove cable management covers (if necessary) from
short throw projector arm. (See Figure 26)
(bottom view)
3
small cable cover
Figure 26
Installation Instructions
2
3
large cable cover
projector
Advertisement
Table of Contents
