Table of Contents
Advertisement
Installation Instructions
Pitch Adjustment
NOTE:
Pitch can be adjusted using the projector mount or the
pitch of the entire arm can be adjusted. See "Pitch
Adjustment - Entire Arm Section for details.
1.
Loosen Pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 21)
2.
Turn Pitch micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 21)
3.
Tighten Pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 21)
2
2
Figure 21
Roll Adjustment
1.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 22)
2.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 22)
3.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 22)
1
3
2
Figure 22
Visit the InFocus support site at www.infocus.com/support
Cable Management (Optional)
1.
2.
NOTE:
1
3
3.
(underside)
NOTE:
2
4.
Remove two screws #8-32 x 1/2" Phillips pan machine
screws (F) to release mount cover. (See Figure 23)
Slide mount cover away from wall mount. (See Figure 23)
(F) x 2
1
Figure 23
In most cases, cable management covers will NOT
need to be removed in order to route cables from
projector to the wall mount. But for some thick cables,
removing the covers may be necessary.
Remove cable management covers (if necessary) from
short throw projector arm. (See Figure 24)
(bottom view)
3
small cable cover
Figure 24
Cables may be routed from below and up wall bracket
channel, or from above and down behind and into wall
mount.
•
Routing Cables from Below (Steps 4 and 5)
Open cable clips along bottom edge of wall bracket cross
bracket (See Figure 25)
SP-WALLKIT-02
2
3
large cable cover
projector
11
Advertisement
Table of Contents
