Table of Contents
Advertisement
Installation Instructions
Pitch Adjustment
NOTE:
Pitch can be adjusted using the projector mount or the
pitch of the entire arm can be adjusted. See Pitch
Adjustment - Entire Arm section for details.
1.
Loosen Pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 19)
2.
Turn Pitch micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 19)
3.
Tighten Pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 19)
2
2
Figure 19
Roll Adjustment
1.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 20)
2.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 20)
3.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 20)
Visit the InFocus support site at www.infocus.com/support
1
1
3
Removing Mount Covers
1.
Remove two #8 x 1/2" Phillips pan tapping screws (U) and
two #10 x 1" Phillips pan tapping screws (V) to free top cover
(C) and expose pitch adjustment screw. (See Figure 21)
2.
Remove lower cover (D) from PRJ-WALLKIT-11. (See
Figure 21)
1
(C)
3
2
Figure 20
1
(U) x 2
1
Figure 21
PRJ-WALLKIT-11
2
(V) x 2
(D)
2
11
Advertisement
Table of Contents
