Advertisement
Quick Links
I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Dual Stud Short Throw Wall Mounts
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Spanish Product Description
German Product Description
Portuguese Product Description
French Product Description
PRJ-WALLKIT-12
Italian Product Description
Dutch Product Description
Advertisement
Related Manuals for InFocus PRJ-WALLKIT-12
Summary of Contents for InFocus PRJ-WALLKIT-12
- Page 1 I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Istruzioni di installazione Installationsanleitung Installatie-instructies Instruções de Instalação Instructions d´installation Dual Stud Short Throw Wall Mounts Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description PRJ-WALLKIT-12...
-
Page 2: Important Safety Instructions
The information contained in this document is subject to change without notice or obligation of any kind. InFocus makes no WARNING: Failure to provide adequate structural strength representation of warranty, expressed or implied, regarding the for this component can result in serious personal injury or information contained herein. - Page 3 Hex-Head Wrench Security Wrench Llave de cabeza hexagonal Llave de seguridad Sechskantschlüssel Sicherheitsschlüssel Chave de cabeça sextavada Chave de segurança Chiave esagonale Chiave di sicurezza Zeskantsleutel Veiligheidssleutel Clé à tête hexagonale Clé de sécurité Visit the InFocus support site at www.infocus.com/support...
- Page 4 1/4-20 x 5/8" 1/4-20 x 3/8" 1/4-20 x 1-1/2" #8-32 x 1/2" [not used] [not used] Z (1) AA (4) 3/16" Y (4) X (4) #10-24 x 3/8" [Concrete anchor] #10-24 x 1-3/8" [not used] Visit the InFocus support site at www.infocus.com/support...
- Page 5 Steel Stud (2 x 4 / 25ga minimum) Stud type and structural strength must conform to the North American Specification for the Design of Cold-Formed Steel Structural Members. [362, 125 18, C-Shape, S - Stud Section] Visit the InFocus support site at www.infocus.com/support...
-
Page 6: Install Four 5/16 X 2-1/2" Hex Head Lag Screws (J) Through
PRJ-WALLKIT-12 Installation Instructions Assembly and Installation The PRJ-WALLKIT-12 short throw projector mounts can be mounted to concrete, concrete block, wood studs or steel studs. (J) x 4 They can be mounted to studs up to 16" apart. For studs more (K) x 4 than 16"... - Page 7 (See Figure 8) (front view) steel studs Repeat Steps 5 through 8 for each mounting hole. Steel Stud Drywall Plastic Cap Plastic Straps Anchor Metal Channel (side view) Figure 5 Figure 8 Visit the InFocus support site at www.infocus.com/support...
-
Page 8: Figure
Installation to Wall Bracket Lift short throw projector arm (A) up to wall bracket (B) and hook top plate onto cross bracket on wall bracket. (See Figure 10) (T) x 2 Figure 12 Figure 10 Visit the InFocus support site at www.infocus.com/support... - Page 9 (C), lower cover (D) and into wall Line up mounting holes on projector mount (H) with mount with two 8-32 x 1/2" Phillips pan head screws (U). corresponding holes on mounting plate. (See Figure 16) (See Figure 15) Visit the InFocus support site at www.infocus.com/support...
- Page 10 NOT substitute hardware. Use only the hardware provided by Mounting screw the manufacturer. with thumb nut Secure interface bracket (G) to top of InFocus projector (not seated in included) using hardware and instructions included with the mounting slot interface bracket.
- Page 11 Turn Pitch micro-adjustment screw right or left using a #2 Phillips screwdriver until image is properly aligned on target. (See Figure 21) Tighten Pitch adjustment locking screw using a #2 Phillips screwdriver. (See Figure 21) Figure 22 Visit the InFocus support site at www.infocus.com/support...
-
Page 12: Visit The Infocus Support Site At Www.infocus.com/Support
Remove lower cover from mount. (See Figure 24) cable clips x 4 Figure 26 Thread cable up wall bracket channel and into opened cable clips. (See Figure 27) Proceed to Step 8 Cables (example) Figure 24 Figure 27 Visit the InFocus support site at www.infocus.com/support... - Page 13 Route cables through cover mount, projector arm tunnel (See Figure 31) and into projector. (See Figure 29) Cables (example) Cable clips Figure 31 11. Return outer covers to the mount following instructions in Installing Mount Covers section. Figure 29 Visit the InFocus support site at www.infocus.com/support...
- Page 14 (See Figure 35) (U) through holes in covers and wall bracket. (See Figure 33) (U) x 4 (bottom view) (U) x 4 (T) x 2 (Projector arm not shown) Figure 33 Figure 35 Visit the InFocus support site at www.infocus.com/support...
-
Page 15: Prj-Wallkit
Wall Bracket Covers Remove eight #8-32 x 1/2" Phillips pan machine screws (U) (bottom view) from wall bracket covers. (See Figure 39) (U) x 8 Figure 37 (Projector arm not shown) Figure 39 Visit the InFocus support site at www.infocus.com/support... - Page 16 For most projectors, it will be necessary to remove projector prior to install four security screws to projector bracket. For ease of installation, it is recommended to remove projector prior to performing the following steps. (R) x 2 Figure 41 Visit the InFocus support site at www.infocus.com/support...
- Page 17 Step 2 and into plastic spacer. (See Figure 45) Repeat Steps 2-3 for remaining three bolts one bolt at a time. Adapter plate Plastic spacer (Q) x 4 (one at a time) Figure 45 Visit the InFocus support site at www.infocus.com/support...
- Page 18 PRJ-WALLKIT-12 Installation Instructions Visit the InFocus support site at www.infocus.com/support...
- Page 19 Installation Instructions PRJ-WALLKIT-12 Visit the InFocus support site at www.infocus.com/support...
- Page 20 PRJ-WALLKIT-12 Installation Instructions InFocus Corporation 13190 SW 68th Parkway, Ste 200 Portland, OR 97223 8800-002229 Rev00 2012 InFocus Corporation www.infocus.com 09/12...
Need help?
Do you have a question about the PRJ-WALLKIT-12 and is the answer not in the manual?
Questions and answers