Table of Contents
Advertisement
•
Select 1 to change the number of interface card LUNs reported by the interface card. This value can
be set to a number in the range of 0 to 4.
•
Select 2 to change the location of LUNs in an auto-assigned map. LUNs can be positioned starting at
the beginning (first location) or at the end (last location) of the map.
For more information on interface card LUNs, see
Save configuration
This option saves the current configuration state in FLASH, which updates the saved previous
configuration state. Saved changes are retained across future device resets or power cycles.
Restore last saved configuration
This option restores the most recently saved configuration. This can be useful when configuration changes
are made, but the user wishes to return to the previously saved configured state. The changes take effect
after the interface card has rebooted.
Reset to factory defaults
This option resets all current configuration options to the factory defaults and saves those options to FLASH
memory as the current configuration. The changes take effect after the interface card has rebooted.
System utilities
Figure 63
System utility menu
X.XX.XX
1) System Statistics Menu
2) Event Log
3) Runtime Report
4) Enter System Diagnostics Mode
5) Special Fibre Channel Link States
6) SCSI Command Tracking
X) Return to main menu
•
Select 1 to display the System Statistics menu, described later in this chapter.
•
Select 2 to display the Event Log menu, described later in this chapter.
•
Select 3 to view the Runtime Report, described later in this chapter.
•
Select 4 to enter diagnostics mode. A confirmation message appears verifying that you want to do
this. If you enter N for No, you are returned to the System Utilities menu. If you enter Y for Yes, the
interface card enters System Diagnostics Mode. This option is described in more detail later in this
chapter.
•
Select 5 to access a special diagnostic utility. This utility should not be used unless under the guidance
of an authorized HP technician.
•
Select 6 to display the SCSI Command Tracking menu, described later in this chapter.
System Utility Menu
XXXXXX
XXXXXXXXXXXXXXXX
07/7/2005
08:56:22
e1200-320 4Gb Fibre Channel Interface Card user and service guide
"Inband SCSI-3
commands" on page 109.
79
Advertisement
Table of Contents
