Verify Configuration; Verify Mapping; Verify Devices; Verify Host Configuration - HP StorageWorks e1200-320 4Gb Service Manual

4gb fibre channel interface card
Table of Contents

Advertisement

If devices are listed, verify FC HBA mapping mode or AL_PA addresses on the interface card.

Verify configuration

A number of configuration changes may result in an invalid configuration. If you are in doubt about the
configuration, restore the interface card to the factory default configuration and proceed to configure the
unit a step at a time, verifying the functionality of the configuration as changes are made.

Verify mapping

Verify that all desired devices have been discovered and mapped. If using Indexed or SCC mapping, try
swapping to Auto-assigned to see if this solves the problem.
NOTE:
HP recommends that you DO NOT use Auto-Assigned long-term as it exposes the library and
drives to the entire SAN. Instead, a custom map should be created with only the hosts that need to
communicate with the library and the drives assigned to it.

Verify devices

It may be useful to connect the SCSI target devices you are attempting to use to the native SCSI interface
to verify that the devices are functional. SCSI target devices can be connected to a host SCSI bus to verify
they are functional.

Verify host configuration

In some cases, it may be that the FC host bus adapter or host device driver may not be working properly.
Check the configuration of these elements. It may be useful to check the release notes for the driver
provided to see if there are any specific issues or required configuration. It may also be useful to ensure
that you are using a current version of the host bus adapter driver and firmware.

PRLI data

The interface card supports the discovery mechanism. The interface card returns the PRLI response data as
specified in
Table
Table 8
HP e1200-320 4Gb Interface Card PRLI response data
Item
PRLI Command Code
Page Length
Payload Length
Type Code
Type Code Extension
OPA
RPA
IPE
Response Code
Originator Process Associator
Responder Process Associator
Initiator Function
Target Function
Command/Data Mixed Allowed
Data/Response Mixed Allowed
96
Troubleshooting
8.
Value
0x20
0x10
0x10
0x8
0x0
0x0
0x0
0x1
0x1
0x0
0x0
0x1
0x1
0x0
0x0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks e1200-320

Table of Contents