Table of Contents
Advertisement
Fibre Channel configuration
This menu allows for setting the Fibre Channel Address method, Hard Address value, discovery mode,
WWN overrides, tape backup settings, default map value, and FC port mode.
Figure 44
Fibre Channel configuration menu
Current Fibre Channel Configuration -
FC Link Status
Node Name
Port Name
Port Mode
Discovery Mode
Buffered Tape Writes
Current Default Map
Port Speed
1) Change World Wide Name High
3) Toggle Port Mode
5) Toggle Discovery Mode
7) Change Buffered Tape Queue Depth
9) Edit FC Override Settings
A) Toggle Port Speed
X) Return to previous menu
Command >
NOTE:
For In-Band Management to be operational, WWN naming schemes must be compliant with
IEEE Fibre Channel Format 1, where the left-most hexadecimal character (the NAA field) of the WWN is
1. Further, the upper nibble of the third byte (the sixth hexadecimal value from the right) must be a value
of 0 or 1.
•
Select 1 to enter a new value for the World Wide Name High. Ordinarily, this value should not be
changed.
NOTE:
Resetting factory defaults overwrites any value a user has previously manually entered for the
WWN.
•
Select 2 to enter a new value for the World Wide Name Low. Ordinarily, this value should not be
changed.
NOTE:
Resetting factory defaults overwrites any value a user has previously manually entered for the
WWN.
62
Using the Command Line Interface
Fibre Channel Configuration Menu
X.XX.XX
XXXXXX
XXXXXXXXXXXXXXXX
07/7/2005
08:56:22
Port 0:
: DOWN
: 0x100000E0 02031751
: 0x100000E0 02231751
: N_Port Mode
: Manual Discovery Only
: Enabled, Queue Depth = 5
: 'Indexed'
: 2 GigaBit
2) Change World Wide Name Low
4) Change ALPA Value
6) Toggle Buffered Tape Writes
8) Change Default Map Value
Advertisement
Table of Contents
