Network Card Configuration Worksheet - HP A7011A Installation Manual

Network Card Configuration Worksheet

Fill out one worksheet for each network card you are installing.
Table 1-1 Ethernet Card Configuration Worksheet
Required/
Data Type
Optional
Internet Required
Address
Subnet mask Required if
using
subnetting
Station Built-in but
address can be
optionally
changed
Host name Required if
alias for this the system
network is connected
interface to more than
(card) 1 network
Link Required
configuration
Link speed/ Required
duplex mode
MTU Optional
(Maximum
Transmission
Unit): Jumbo
Frames
Receive flow Optional
control
Chapter 1
How to Configure
Default
0.0.0.0 SAM or ifconfig or
edit
/etc/rc.config.d/
netconf
Subnet mask SAM or ifconfig or
not used edit
/etc/rc.config.d/
netconf
As shown on SAM or edit
card
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -A
None SAM or edit
/etc/hosts
Autonegotiating SAM or temporarily:
lanadmin -X
Autonegotiating Hub or switch (see
Note 2) SAM or
temporarily:
lanadmin -X
1500 bytes SAM or edit
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -M
On SAM or edit
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -X
Network Card Configuration Worksheet
(see Note 1)
196.6.20.2
255.255.248.0
0x0060b0c4012f
host1
lanadmin -X
auto_on ppa#
(if already
turned off)
lanadmin -X
100fd ppa#
lanadmin -M
9000 ppa# (see
Note 3 below)
lanadmin -X
fctrl off
HP-UX Installation
Your
Example
System
9