Network Configuration Worksheet - HP AB290A Installation Manual

Hardware and Software Installation Procedure
Network Configuration Worksheet
Network Configuration Worksheet
Fill out one worksheet for the networking data of each LAN port on the combination card you are installing.
Table 2 Network Configuration Worksheet
Required/
Data Type
Optional
Internet Required
Address
Subnet mask Required if
using
subnetting
Station Built-in but can
address be optionally
changed
Host name Required if the
alias for this system is
network connected to
interface (card) more than 1
network
Link Required
configuration
Link Required
speed/duplex
mode
MTU Optional
(Maximum
Transmission
Unit): Jumbo
Frames
Receive flow Optional
control
Note 1: To configure values permanently, edit the configuration files using SAM or an editor such as "vi".
Using lanadmin will not preserve your settings across reboots.
Note 2: The speed configuration of the card can be 10, 100, or 1000Mbps and is determined by the speed
setting of the hub or switch port to which the card is connected. The card automatically senses this speed. The
Base-T ports only run at one speed at a time. To verify the speed selection, run lanadmin -x ppa#.
12
Default
0.0.0.0
Subnet mask not used
As shown on card
None
Autonegotiating
Autonegotiating
1500 bytes
On
How to Configure
(see Note 1)
SAM or ifconfig or 196.6.20.2
edit
/etc/rc.config.d/
netconf
SAM or ifconfig or 255.255.248.0
edit
/etc/rc.config.d/
netconf
SAM or edit 0x0060b0c4012f
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -A
SAM or edit host1
/etc/hosts
SAM or temporarily:
lanadmin -X
lanadmin -X auto_on ppa#
(if already
turned off)
Hub or switch (see
lanadmin -X
Note 2) SAM or
100fd ppa#
temporarily:
lanadmin -X
SAM or edit lanadmin -M
9000 ppa# (see
/etc/rc.config.d/
hpietherconf or Note 3 below)
temporarily:
lanadmin -M
SAM or edit
lanadmin -X
/etc/rc.config.d/ fctrl off
hpietherconf or
temporarily:
lanadmin -X
Your
Example
System