Advertisement
Quick Links
hp
StorageWorks
Caution: Parts can be damaged by
electrostatic discharge. Keep parts in their
containers until needed. Ensure you are
properly grounded when touching static-
sensitive components.
Note: This part is not hot-swappable.
It is necessary to power down the library
to replace this part.
1
Inspect the contents of the kit.
ESL E-Series
e2400-FC 2Gb
Interface
Controller
Upgrade
Caution: Before continuing with this
procedure, ensure the following components
are upgraded to the necessary firmware
versions:
• library: 1.02 or greater
• Interface Manager: I130 or greater
• Command View ESL: 1.3.00 or greater
Refer to the HP StorageWorks Interface
Manager and Command View User Guide
for detailed procedures on checking
firmware revisions and making updates.
Note: These parts are only needed
during the initial library installation with
native Fibre Channel (FC) drives, and they
will not be used as part of this procedure.
For more information, refer to the HP
StorageWorks ESL E-Series Unpacking
and Installation Guide.
Note: These FC cables are not used if
your library contains only LTO4 tape
drives.
Advertisement
Related Manuals for HP ESL E-Series
Summary of Contents for HP ESL E-Series
- Page 1 Fibre Channel (FC) drives, and they will not be used as part of this procedure. For more information, refer to the HP StorageWorks ESL E-Series Unpacking and Installation Guide. Note: These FC cables are not used if your library contains only LTO4 tape Inspect the contents of the kit.
-
Page 2: Controller Installation
Power off the library. Use your backup software to verify that the picker is empty, or to empty the picker. Press the power button located on the front of the library and wait until the OCP goes blank. Open the back door of the library. Controller Installation Using a #1 Phillips screwdriver, remove the blank Flip the two breaker switches off (to the left) at the... - Page 3 FC Cable Configuration Drive TD Port FC cables are labeled near their connectors to indicate which TD port to connect to each port on Connect each FC cable to the appropriately the interface controller. Plan to first connect the labeled TD port on the interface controller. Once FC cables to the interface controller, then route connected, insert the FC cable bundle into the them through the cabinet, and finally, connect...
-
Page 4: Ethernet Cable Connection
Note: You can use the labels provided to indicate which drive cluster the FC cables are interfacing with. Attach one label to each end of the cables. To help keep the FC cables clear of the drive cluster below, attach the cables to the drive handle on the lower right drive in the cluster using the tie wrap provided. -
Page 5: Getting Help
Configuration Getting help • HP product information: http://www.hp.com/go/storage • HP technical support and phone numbers: Use HP StorageWorks Interface Manager http://www.hp.com/support command-line interface or HP StorageWorks • HP StorageWorks Library and Tape Tools Command View TL to verify detection of the (L&TT) diagnostic software:... - Page 6 © 2004-2007 Hewlett-Packard Development Company, L.P. Third Edition (September 2007) Part Number: AA928-96014 *AA928-96014* AA928-96014...