Table of Contents
Advertisement
NOTE:
To use the DHCP feature, a DHCP server must be operational on the Ethernet network. If the DHCP
feature is used when there is not DHCP server, the standard for DHCP requires the interface card wait three
minutes for a response from a DHCP server before timing out.
Some DHCP servers allow an extended lease reservation to be set up for an IP address by providing
the server with the Ethernet MAC address. The DHCP server always provides the same IP address to the
interface card. This setup can be useful for remote management of the interface card via Telnet or VM.
Because the method of setting up an extended lease reservation varies, depending on the DHCP server
being used. Contact the Network Administrator for assistance.
Active fabric configuration
The Active Fabric (AF) screen allows setup of a fibre target LUN for the interface card (see
Figure 20
Active Fabric screen
NOTE:
Increasing the number of Controller LUNS takes effect immediately. For all other changes, the
interface card must be rebooted.
Active Fabric settings:
•
ServerFree Backup Mode:
•
Number of Controller LUNs: (default: 1) sets the number of controller LUNs reported by the interface
card. The number must be in the range of 0 through 4.
•
Controller LUNS in auto-assigned map go: settings are First or Last. Setting the choice to Last is
recommended. Setting the choice to First can cause issues with HP-UX. However, if working with an
OVMS host, it should be set to First.
NOT Supported
e1200-320 4Gb Fibre Channel Interface Card user and service guide
Figure
20).
37
Advertisement
Table of Contents
