Powering On And Off; Interpreting Led Activity; Led Indicators; Identifying Leds - HP Brocade 8Gb User Manual

Powering on and off

8Gb SAN Switch power is provided by the enclosure. The 8Gb SAN Switch runs POST by default
each time power to the enclosure is turned on. The POST process can last as long as three minutes.
To remove power from the switch, remove the 8Gb SAN Switch from the enclosure interconnect bay.
NOTE:
Each time the 8Gb SAN Switch is powered on, its settings are restored to the last saved configuration.

Interpreting LED activity

You can monitor switch activity and status by checking 8Gb SAN Switch LEDs.
There are three possible LED states: no light, a steady light, or a flashing light. The steady lights and
flashing lights can be green or amber.
The LEDs flash any of these colors during boot, POST, or other diagnostic tests. This is normal and
does not indicate a problem unless the LEDs do not indicate a healthy state after all boot processes
and diagnostic tests are complete. A healthy state is indicated by a steady green light. See
15, page 37 for details about LED activity.

LED indicators

All 8Gb SAN Switch LEDs are located on the port side. See
Figure 8 Identifying LEDs
.
Table 14 Front panel LED indicators during normal operation
Item Number
1
2
3
4
36 Managing the 8Gb SAN Switch
Description
Unit ID (UID) LED
Health ID LED
Module status LED
Port status LED
Figure 8 and Table 14.
LED indicators
Steady blue light
Steady green light
Steady green light
Steady green light
Table