1.
Locate the appropriate interconnect bay in the rear of the enclosure as specified in the appropriate
HP BladeSystem Enclosure Setup and Installation Guide provided with your enclosure.
IMPORTANT:
Populate all enclosure I/O bays with the appropriate component (for example a switch,
Pass-Thru, or one of the blank panels provided with the enclosure).
2.
Remove the slot cover (if installed).
CAUTION:
Properly ground yourself before handling the switch.
3.
Press the handle latch to release the installation handle. See
Figure 4 Releasing the installation handle
.
Table 9 Release mechanism components
Item
Description
1
Installation handle in latched position
2
Handle latch
3
Installation handle (released)
NOTE:
The Brocade 8Gb SAN Switch is a hot-pluggable device. The enclosure power may be on
or off during installation.
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
Figure
4.
21