Troubleshooting Tips - Haier QFT15ESSNWW Owner's Manual & Installation Instructions

TROUBLESHOOTING TIPS

Problem
Dryer shakes or Some shaking/noise is normal .
makes noise Dryer may be sitting unevenly .
Clothes take too Improper sorting
long to dry
Large loads of heavy fabrics
(like beach towels)
Non-venting dryer
Controls improperly set
Condenser box is clogged
Lint filter is full
Blown fuses or tripped circuit
breaker
Overloading/combining loads
Underloading
The Dry dryness Load consists of a mixture of
level was chosen heavy and light fabrics
but load is still
Lint filter, condenser, and/or air
damp
intake vent located on the front
of the dryer is blocked
Dry Sensor is dirty
Control buttons Controls accidentally put in
not responding service mode
Controls accidentally put in
lock mode
Controls performed an
incorrect operation
Dryer doesn't Control panel is "asleep"
start
Dryer is unplugged
Fuse is blown/circuit breaker is
tripped
Dryer was accidentally paused
when starting Delay Dry
Water tank is full
No numbers Dryer is continuously
displayed during monitoring the amount of
cycle, only lights moisture in the clothes
24
Possible Cause
Move dryer to an even floor space, or adjust leveling legs as necessary
until even.
Separate heavy items from lightweight items (generally, a well-sorted
washer load is a well-sorted dryer load).
Large, heavy fabrics contain more moisture and take longer to dry.
Separate large, heavy fabrics into smaller loads to speed drying time.
Condensing dryers usually take longer to dry than a vented dryer.
Match control settings to the load you are drying.
Remove and clean the condenser box. Also, clean the location where
the condenser box is located ensuring all seals are free from debris.
Put the condenser box back and lock it in place. See Condenser in the
Care and Cleaning section.
Clean lint filter before every load.
Replace fuses or reset circuit breakers. Since most dryers use 2 fuses/
breakers, make sure both are operating.
Do not put more than one washer load in the dryer at a time.
If you are drying only one or two items, add a few items to ensure proper
tumbling.
When combining heavy and light fabrics in a load, choose More Dry .
Inspect and clean lint filter, condenser, and/or air intake vent located on
the front of the dryer.
Clean the sensor with a moist cloth.
Press Start/Pause .
Hold the Lock Control button for 3 seconds to unlock the dryer.
Reset the in-house breaker.
This is normal. Press Power to activate the control panel.
Make sure the dryer plug is pushed completely into the outlet.
Check the building's fuse/circuit breaker box and replace fuse or reset
breaker. NOTE: Electric dryers use two fuses or breakers.
If the light on the Start/Pause button is flashing, the dryer is paused.
Press Start/Pause to restart the countdown.
If the Empty Tank light is on, you must empty the water tank before the
dryer will start. Refer to the Care and Cleaning section for instructions
on emptying the water tank.
This is normal. When the dryer senses a low level of moisture in the load,
the dryer will display the dry time remaining.
What To Do
49-3000193