7-6. Cleaning Gun Liner
1
2
3
8 mm
Remove nozzle. Cut off wire
at contact tip, and remove
contact tip and tip adapter.
Tools Needed:
8 mm
Head
Tube
Open pressure assembly. Retract
wire from liner onto spool.
Lay gun cable out straight,
and blow out liner.
!
1
2
3
Remove screws (3) from
cover, and remove cover
from wire drive assembly.
.
Reassemble drive cover
and gun in reverse order
from taking it apart.
Turn Off welding power source.
Nozzle
Contact Tip
Adapter
.
Hold wire tightly to keep it
from unraveling. Secure
end of wire at spool.
Thread wire according to
Section 5-9.
804 241-A / 803 838-A
OM-947 Page 27