Changing Nozzle, Contact Tip, Adapter And Liner, And Cleaning Gun Casing - Hobart 210 MVP Owner's Manual

7-5. Changing Nozzle, Contact Tip, Adapter And Liner, And Cleaning Gun Casing

1
8 mm
Remove nozzle,
contact tip, and
adapter.
Stickout
Tools Needed:
8 mm, 10 mm
OM-260 274 Page 28
.
A complete Parts List is available at www.HobartWelders.com
2
3
Head
Tube
Blow out
gun casing.
5/8 in.
(16 mm)
Liner
! Turn off welding power
source.
1 Nozzle
2 Contact Tip
3 Tip Adapter
.
Wire size stamped on tip − check
and match wire size.
Cut off wire and
disconnect gun
from feeder.
Lay gun cable out
straight before
installing new liner.
Reassemble gun in
reverse order from
taking it apart.
.
Thread wire according to
welding power source/wire
feeder manual.
Unscrew and
remove liner.
10 mm
Install
Liner
243 839-A