Section 5 − Installation; Installing Work Clamp - Hobart Handler 125 Owner's Manual

5-1. Installing Work Clamp

.
Tools Needed:
7/16 in.
SECTION 5 − INSTALLATION
Connection hardware must be tightened with proper tools. Do not just
hand tighten hardware. A loose electrical connection will cause poor
weld performance and excessive heating of the work clamp.
1
6
2
5
7/16 in.
1 Nut
2 Work Cable From Unit
3 Work Clamp
4 Screw
5 Work Clamp Tabs
Bend tabs around work cable.
6 Insulator Grip
3
Slide one insulating grip over work
cable before connecting to clamp.
Slide insulating grips over handles.
4
Ref. 802 456
OM-947 Page 13