Powerware Prestige series 9 User Manual page 39

Powerware 9 Prestige Series User's Guide (600 VA - 1800 VA)
®
4. Press and hold the Output On button until the alarm beeps
again.
Two indicators, corresponding with the current setting, remain
flashing. The output voltage is factory-configured for 230V.
OVERLOAD
SITE FAULT
OVERTEMP
BATTERY
SELF TEST
5. Press the Output
voltage options, top to bottom. Each time you press the button,
the UPS beeps and the next two indicators flash.
NOTE If you do not save a selection within two minutes, the setup automatically
aborts and switches back to the original configuration.
6. Press and hold the Output On button until the alarm beeps to
select and save the output voltage. Failure to release the button
immediately after the beep will cause the UPS to abort the
setup.
7. Continue to Step 10.
8. Plug the UPS power supply cord into the input connector on
the UPS rear panel.
9. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance
with national wiring rules.
10. The equipment to be protected by the UPS should be powered
off. Plug the equipment into the power output receptacles on
the UPS rear panel.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
The optional PowerPass has a surge-protected receptacle for
laser printers.
11. Turn on the equipment that is connected to the UPS.
:
240V 230V
Figure 5. Output Voltage Indicators
Off button to scroll through the output
www.powerware.com
Installation
220V 208V
33