The password protection will prevent the changing of the calibration data and address.
The default password is "0" (zero). When the password is "0" the password protection is
turned off.
When setting the password for the first time, "0" must be entered as the Old Password.
The password can be reset to "0" as long as the current password is known.
The password can be up to eight alpha/numeric characters long and is case sensitive.
Program Exit Password
From the Menu select Setup | Password | Program Exit
This password protection will prevent closing LEMCal software. This is most useful
when the Logfile function is being used, and a record without gaps is desired. The default
password is "0" (zero). When the password is "0" the password protection is turned off.
When setting the password to the first time, "0" must be entered as the Old Password.
The password can be reset to "0" as long as the current password is known.
The password can be up to eight alpha/numeric characters long and is case sensitive.
Figure 2-6. Select Password
Figure 2-7. Change Exit Password
2
Getting Started
Software Setup
gky09.bmp
gky10.bmp
2-5