Table of Contents
Advertisement
ASSEMBLY
Before beginning assembly, carefully read the
following Information
and Instructions:"
• Place all parts of the home gym system in a
cleared area and remove the packing materials;
do not dispose of the packing materials until
assembly is completed.
• The assembly is divided into four stages: 1)
frame assembly, 2) press, squat, and butterfly
arm assembly, 3) cable and pulley assembly, and
4) seat and backrest assembly. The hardware for
each stage is packaged separately.
• Wait until you begin each assembly stage to open
that parts bag.
• For help identi_ing the small parL_used in
assembly, use the PART IDENTIFICATION
CHART located In the center of this manual.
Note: Some smal_ parts may have been pre*
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attashed.
• As you assemble the home gym system, be sure
that all parts are oriented as shown in the
drawings.
• "Tightenall parts as you assemble them, unless
Instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) phillips screwdriver
• One (1) rubber mallet
• Lubdcent, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
_i_ _¸_¸¸ _!
UL
1.
Before beginning assembly, be sure that
you have read and understand the Infor-
mation In the box above.
Press a 2" Square Inner Cap (27) into the
end of the Rear Base (51). Press a 2" Square
Cover Cap (78) onto each end of the
Stabilizer (5).
Insert two 5/16" x 2 1/2" Carriage Bolts (1)
up through the Rear Base (51). Insert two
5/16" x 2 3/4" Bolts (11) through the Rear
Base and Stabilizer (5) as shown,
2.
Press a 2" Square Inner Cap (27) into the
end of the Front Base (4).
Insert two 5/16" x 2 112"Carriage Bolts (1)
up through the Front Base (4), Slide the
Front Base onto the two 5/16" x 2 3/4" Bolts
(11) in the Rear Base (51) and Stabilizer (5).
Hand-tighten two 5/16" Nylon Locknuts (3)
onto the Carriage Bolts. Do not tighten the
Nylon Locknuts yet.
2
11
78
<
11'
1
3
11 " :'__.
4
27
4
Hide quick links:
Advertisement
Table of Contents
