Table of Contents
Advertisement
ii_ _i _
During steps 15 through 36, refer to the
CABLE DIAGRAM on page 23 of this manual
to verify proper cable routing. Before begin-
ning this section, identify the Long Cable (86),
the Medium Cable (23), and the Short Cable
(58) by comparing the lengths and ends of the
cables.
IMPORTANT: While assembling
the cables,
do not overtlghten the bolts and nuts
securing the pulleys. The pulleys must be
able to turn freely.
15. Locate the Medium Cable (23). Wrap the
Medium Cable around a 3 1/2" Pulley (15).
Attach the Pulley to the Top Frame (55) with a
3/8" x 3 3/4" Bolt (71) and a 3/8" Nylon
Locknut (21). Be sure that the end of the
Cable with the ball Is on the indicated side
.......
of the Pulley and that the Cable is between
the Pulley and the hook.
iiiiiili_ii! 1 16. Wrap the Medium Cable (23) around a =V"-
Pulley (6). Attach the "V_-Pulley and a Long
ii!!!!i<lCi!
Cable Trap (50) to the indicated bracket on
the Front Upright (42) with a 3/8" x 2 1/2" Bolt
(7) and a 3/8" Nylon Locknut (21). Be sure
that the Long Cable Trap Is positioned to
hold the Cable In place.
iii!ili!!!
i!iiiii
17. Route the Medium Cable (23) around the =V"-
Pulley (6) on the Left Arm (47). Be sure that
the Cable Is In the groove of the Pulley and
that the Long Cable Trap (50) Is positioned
to hold the Cable In place. Tighten the 3/8" x
2 112"Bolt (7) and the 3/8" Nylon Locknut (not
shown).
14
_ _
'' _-86
(174")
:_ _
_-_-,_23
(159")
:L
u
,
58 (47")
15
16
17
21_
;5
._'-23
Hook
71
//
7---q
6
7
50
47
23
9
Hide quick links:
Advertisement
Table of Contents
