Weider Pro 9625 User Manual page 6

!iii i _ii_i _ i_i
ii_ii _ i_:_i_i!iiii_
ill _:_!_iiii_i
!i!!_i!_ _i!_ii _
_ _iii_ii_i i_
_i_ _ i_i
,
Set two Weight Bumpers (19) onto the bracket
on the Stabilizer (5). Insert both Weight Guides
through the Weight Bumpers and the bracket
on the Stabilizer. Be sure that the drilled
holes In the Weight Guides are at the top,
as shown. Press a 1" Round Cover Cap (70)
onto the bottom of each Weight Guide (62).
Slide eight Weights (25) on the Weight
Guides (62). Be sure that all of the Weights
are turned so the pin grooves are on the
same side.
.
Press the Weight Tube Bumper (64) into the
end of the Weight Tube (63). Insert the
Weight Tube into the stack of Weights (25).
Be sure that the pins on the Weight Tube are
resting in the pin grooves in the upper
Weight.
Lubricate the insides of the holes in the Top
Weight (76). Slide the Top Weight onto the
Weight Guides (62) and set it on the stack of
Weights (25).
.
Press a 2" Square Inner Cap (27) into each.
end of the Top Frame (55). Press a 1 3/4"
Square Inner Cap (44) into each end of the
crossbar on the Top Frame. Press two 1"
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16"
x 2 3/4" Bolts (11), four 5/16" Flat Washe_'s
(8), and four 5/16" Nylon Locknuts (3).
5
6
7
Drilled holes must
7 be at the top
7 62
Pin Grooves must
be on this side
11
55
6