Generator Adapter Cord Set - Troy-Bilt 30237 Owner's Manual

Section 4: Operation
For a more permanent shelter, build a structure that wHH
enclose three sides and the top of the generator.
7. Hake sure entire muffleroside of generator is exposed,
as shown in Figure HO.
iMPORTANT: The generator must be at Heast S ft.
(H52 cm) from structures having combusdbHe walls and/or
other combustibHe materials. Leave at Heast 3 ft. (92 cm) aH
around generator inchding overhead, for adequate cooHing,
maintenance and servicing.
8. Face exposed end away from wind and eHements.
9. Structure shouH hoH enough heat created by the
generator to prevent icing proMem.
H0. Start and run engine outdoors.
HH. Keep exhaust gas from entering a confined area
through windows, doors, ventilation intakes or other
openings.
WAP, NING
Operate generator ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate generator inside an), building or enclosure
(even if doors or windows are open)_ including the generator
compartment of a recre_tionaI vehicle (RV).
12. DO NOT enclose generator any more than shown in
Figure I 0.
13. Remove shelter when temperatures are above 40°F
[4°q.
14. Turn engine OFF and let cool two (2) minutes before
refueling.
G E N E RATO P, ADAPTE P,
CORD SET
The generator is equipped with a 25' generator adapter
cord set designed for a 240 Volt, 30 Amp grounded neutral
circuit (Figure I I).The generator adapter cord set provides
a convenient supply of emergency power into your dwelling
so that your generator can be operated safely outside.
The maximum load on each outlet is 20 Amps.The
maximum total load on both yellow wire outlets or both
bhck wire outlets is 30 Amps.
NOTE: Follow all safety precautions when connecting any
extension cord or device to the generator.