Table of Contents
Advertisement
* 1 Only when using a graphic accelerator
board that is capable of displaying
852 × 480.
*2 This signal is converted
to a 1024 dots × 640 lines signal,
*3 The picture is displayed in the original resolution.
*4 The aspect ratio is 5:4. This signal is converted
to a 960 clots × 768 lines signal.
*5 Normally
the RGB select mode suite for the input signals is set automatically.
If the picture is not displayed properly, set the
RGB mode prepared
for the input signals listed in the table above,
*6 To connect the monitor to Macintosh
computer,
use the monitor adapter (D-Sub
15-pin) to your computer's
video port. If
your computer
has a mini D-Sub 15-pin connector,
you may have to use the supplied RGB cable,
*7 Other screen modes (ZOOM and STADIUM)
are available as well.
NOTE:
• Whiletheinputsignalsc_m_lywiththeres_luti_nlistedinthetableab_ve_youmayhavetoadjustthep_siti_nandsize
of the picture or the fine picture
because
of errors in synchronization
of your computen
• When a 1280 dots
X 1024 lines signal
or 1600 dots
X 1200 lines signal
is input to the monito_
the picture
will be
compressed.
• This monitor
has a resolution
of 1365 dots X 768 lines. It is recommended
that the input signal
should be XGA, wide
XGA, or equivalent.
• With digital
input some signals are not accepted.
• The sync may be disturbed
when a nonstandard
signal
other than the aforementioned
is input.
• lfyou
are connecting
a composite
sync signal,
use the HD terminal.
* "IBM PC/AT" anti "VGA" are registered
trademarks
of International
Business
Machines,
Inc. of the United States.
* "Apple Macintosh"
is a registered
trademark
of AppLe Computer,
Inc. of the United States.
56
Advertisement
Table of Contents
