Install Refractory - Heat & Glo ESC-42ST Owner's Manual

G. Install Refractory
CAUTION: Refractory pieces are fragile! Carefully
remove the refractory pieces from the packaging.

1. Side refractory panels are held in place by either four
pre-installed clips or four hand bend refractory retainers
formed from the top heat shield. Install side refractory
with the notched end of the refactory on the bottom.
See Figure 14.14 and Figure 14.15. Ensure that side
refractory panels are centered left to right and do not
extend past the outer fi rebox fl ange. Either secure
refractory with refractory clip and screw, or bend down
hadnd bend feature from the top heat shield.
Figure 14.14 Notched End of Side Refractory
2. Install the left and right refractory middle base refractory
pieces on top of the left and right bottom refractory
standoffs. See Figure 14.16 and 14.17. Position so
that the edge is fl ush with the ember light housing.
OUTER FIREBOX OUTER FIREBOX
FLANGE FLANGE

Figure 14.15 Refractory Clip Installation
50
NOTCH NOTCH
LOCATION OF HAND BEND LOCATION OF HAND BEND
FEATURE (NOT SHOWN) FEATURE (NOT SHOWN)
REFRACTORY REFRACTORY
CLIPS CLIPS
Heat & Glo • ESC-42ST • 2146-900 Rev. Q • 4/13
Figure 14.16 Positioning Inner Bottom Refractory
FLANGE FLANGE
Figure 14.17 Positioning Left and Right Middle Base Refractory
Figure 14.18 Positioning Outer Bottom Refractory.
5. Install two outer bottom refractory pieces as shown
in Figure 14.18. Ensure that outer bottom refractory
pieces do not extend past the outer fi rebox fl ange.