Install The Log Assembly - Heat & Glo ESC-42ST Owner's Manual

J. Install the Log Assembly
Log Set Assembly: LOGS-ESC42ST
For Model: ESC-42ST
CAUTION: Logs are fragile! Carefully remove
the logs from the packaging.
Figure 2
GRATE:
Locate the pilot assembly. The pilot assembly is denoted in this instruction by a black or white arrow
each photo. For the purpose of placing logs according to this instruction, begin with the pilot on the left side. Position grate
by locating the four indentations on the bottom refractory. Place grate legs in the indentations as shown in Figure 3.

1 1
Figure 4
LOG NUMBER 1 (SRV2146-701):
#1 onto the grate and pull forward so that the indentation on the front of the log engages the left grate tine. The "burnt" tip
of Log #1 should rest on the burner. The log must NOT block any burner ports. See Figure 4.
52
PILOT
LOG ENGAGES
GRATE TINE
Locate the pilot assembly. It should be on the left side of the fi replace. Place log
Heat & Glo • ESC-42ST • 2146-900 Rev. Q • 4/13
LOG PLACEMENT
1 1
3 3
5 5
7 7
Figure 1
Figure 3
Figure 5 Reverse View
INSTRUCTIONS
2 2
4 4
6 6
8 8
9 9
() on
1 1

2146-936C