There is interference on the radio and/
or television when the analogue
controller is switched on
Before following the steps below, ensure all units are switched
off.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the 502 Analogue
Controller and its cabling.
Ensure that the receiver uses well-screened antenna cable.
Relocate the receiver with respect to the analogue controller.
Connect the receiver and this product to different AC outlets.
Communication is not working
between the 502 Analogue Controller
and other Meridian products
Check that all products are interconnected using the correct
comms leads.
If the installation includes 200 Series or 600 Series units,
check that all 500 Series units are set to 200 mode.
A source cannot be copied to the tape
outputs
Check that you do not have the source set up as a Tape
source; see Configuring the sources, page 16.
31
Need help?
Do you have a question about the 502 and is the answer not in the manual?