Meridian 502 User Manual page 21

To configure a source
Switch off the analogue controller, using the power switch on
the back panel.
Switch on the power again while holding down the Display
key on the front panel.
The display will show:
Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
Press Copy (front panel), or > > > > > and < < < < < (remote), to step
between options.
The right-hand pair of characters shows the current value of the
option.
The options are summarised in the table shown on the next
page.
To change an option
When you have finished programming sources:
C o n f i g
C D C D
Press A or V to step between the alternative values for the
option.
Switch off the analogue controller, using the power switch on
the back panel.
Switch on again to restore normal operation.
17