Chicago Electric 93213 Set Up And Operating Instructions Manual page 11

FIguRE 7
6. Hold it at that position while you tighten
the Lock Stop (6) so that the wheel will
only go down to that point. See FIguRE
7.
7. Depending on the amount of material
you wish to remove, tighten or loosen the
Lower Knob (26) and set the Lock Nut.
See FIguRE 5. The Lower Knob (26)
has a Lock Nut which will determine how
much material is removed. Once you
set the Lock Nut, fully tighten the Lower
Knob (26).
Handle
(34)
8. Lock the chain in the Sliding Guides (31)
by turning the Handle (34). See FIguRE
8. The Handle (34) should be situated so
that you can easily release and tighten it.
You will need to release it each time you
SKU 93213
Lock Stop (6)
FIguRE 8
Limiting
gauge
For technical questions, please call 1-800-444-3353.
move to the next link, and tighten it to
sharpen each link.
FIguRE 9
9. If the chain has been repeatedly
sharpened, the chain depth limiting
gauges may need to be taken down with
a flat file (not included). See FIguRES
8 & 9. File down each gauge so that
they are at a lower level than the cutting
teeth.
Sharpening
1. Put on your protective gear and make
sure the immediate area is clear of
bystanders.
2. Plug in the Power Cord (3) and push the
Switch (5B) to turn on the machine.
Page 11