Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Pacific hydrostar 68333 Manual

maintenance and Servicing

tO PREvEnt SERiOuS injuRy FROm
aCCiDEntal OPERatiOn:
turn the Power Switch of the tool off, unplug the
tool from its electrical outlet, shut off the water
supply and safely discharge all residual water
pressure from the unit before performing any
inspection, maintenance, or cleaning procedures.
tO PREvEnt SERiOuS injuRy
FROm tOOl FailuRE:
Do not use damaged equipment. if abnormal
noise or vibration occurs, have the
problem corrected before further use.
Cleaning, maintenance,
and lubrication
1. before each use, inspect the general condition
of the Pressure Washer. Check for loose screws,
misalignment or binding of moving parts, damaged
electrical wiring, damaged High Pressure Hose,
damaged accessories, and any other condition that
may affect its safe operation. If abnormal noise or
vibration occurs, have the problem corrected before
further use. Do not use damaged equipment.
2. to clean, remove excess water from the Pump by
tipping the unit to drain any remaining water from
the inlet and outlet fittings. Drain the Detergent
Dispenser and flush with running water. Use only a
clean cloth and mild detergent to clean the body of
the Pressure Washer. Do not use solvents.
Do not immerse any part of the tool in liquid. Dry off
Page 12 For technical questions, please call 1-800-444-3353.
any remaining water on all parts and fittings.
Remove mineral deposits from the nozzle using
a thin, stiff wire. The more minerals that are
dissolved in the water (the harder the water)
you use, the more often mineral buildup will
need to be cleaned out from inside nozzle.
3. In areas that have hard water (water rich in minerals
such as calcium) the unit will need to be cleaned
periodically to remove calcium buildup which can clog
the system. To clean off calcium buildup: Unplug the
unit and lay it face down. Fill the body at the water
inlet fitting with calcium remover and allow at least 5
hrs for calcium deposit to break down. Rinse and dry.
4. StORaGE: When storing, empty the Pressure
Washer of water. Frost will damage the Pressure
Washer if the unit contains water. Store the Pressure
Washer in a dry, frost-free room. Flush the unit with
automotive antifreeze prior to long-term storage.
Dispose of antifreeze according to local ordinances.
5. WaRninG! if the supply cord or GFCi unit
of this power tool is damaged, it must be
replaced only by a qualified service technician.
SKU 68333