Technical Specifications; Servicing - Pacific hydrostar PACIFIC HYDROSTRAR 97005 Set Up And Operating Instructions Manual

tEcHNIcAL
SPEcIFIcAtIONS
Engine Type
Displacement
Rotation
viewed from PTO
(power takeoff - the output
shaft)
Type
Fuel
Capacity
Type
Engine
Oil
Capacity
Types
Spark Plug
Gap
Engine California Emissions
Approvals U.S. EPA Phase II
Pump RPM 3400 RPM
Water Flow 4.0 Gal. Per Minute
Pressure
4,000 PSI
Rating
Pump Inlet 30 PSI/4 Gal. Per Minute (Minimum)
Pressure 80 PSI (Maximum)
Hose
5/16" I.D.
Required
Type
Pump Oil
Capacity
Water Temperature
Nozzles Included
Spray Gun Type
Hose Length
Hose Fittings
Hose Pressure
Wheel Size & Inflation
SKU 97005 For technical questions, please call 1-800-444-3353.
13 HP / OHV
Recoil Start
Air Cooled
3600 RPM
390cc
Counterclockwise
(Facing the Shaft)
89+ octane unleaded gasoline
1.7 Gallons
SAE 25W (above 32° F)
SAE 15W-40 (at 32° F or below)
37.2 Ounces (1.1L)
LG F7RTC
0.027" to 0.031"
SAE 25W (above 32° F)
SAE 15W-40 (at 32° F or below)
15.2 Ounces (0.45L)
°
Up to 104° F / 40 C
0° (Red)
15° (Yellow)
40° (white)
Chemical (Black)
Safety Lock-Off Triggered
Handle
32 Ft.
Quick Connect
6000 PSI Maximum
4.10/3.50 Pneumatic
30 PSI (Cold)

SERvIcING

WARNING
from accidental starting. turn
the Power Switch of the
equipment to its "OFF"
position, wait for the engine to
cool, and unplug the spark
plug wire(s) before performing
any inspection, maintenance,
or cleaning procedures.
damaged equipment can fail,
causing serious personal
injury. do not use damaged
equipment. If abnormal noise,
vibration, or excess smoking
occurs, have the problem
corrected before further use.
Maintenance Procedures
Many maintenance procedures,
including any not detailed
in this manual, will need to
be performed by a qualified
technician for safety. If you
have any doubts about your
ability to safely service the
equipment or engine, have a
qualified technician service the
equipment instead.
Engine Oil change
cAUtION! Oil is very hot during
operation and can cause burns. Wait
for engine to cool before changing oil.
1. Place a drain pan (not included)
underneath the Crankcase's Drain
Plug (14). (See Figure K, next
page.)
Risk of serious
personal injury
REv 09b
Page 15